Safeline STANDARD SERIES Manual de Instruções descarregar pdf (Página 60)

Page 44

CONNECTION OF PRINTER TO DETECTOR

NOTES

1) Many printers do not require CTS, DSR or DCD to be at active levels.

However it is accepted good practice to connect these signals together as shown.

2) The printer pin numbers shown are for an RS232 25-way D-type connector - if your

printer uses a 9 way D-type connector consult the printer manual for the correct pin numbers.

3) These are the terminal numbers of the COM1 connectors on the P/S

Connection PCB within the Power Unit Enclosure.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 80 81

STANDARD SERIES 1
METALDETECTORS 1
INSTRUCTION MANUAL 1
FIRMWARE 2.01 TO 2.49 1
Amendments 3
Warnings and Cautions 4
Handling instructions 5
Safety Instructions 6
Detector Precautions 7
CONTENTS 9
LIST OF ILLUSTRATIONS 10
BASICS ABOUT METALDETECTORS 15
INSTALLATION 17
Installing the Power Unit 18
Magnetic Loops 18
Installing the Detector Head 18
LINK 2 (NOTE 1) 20
Figure 6B Power Connections 21
(one end only) 23
Safeline 27
THE DISPLAY 28
AND TOUCH KEY FUNCTIONS 28
OPERATING 28
AND ACCESS MODES 28
AND ACCESS MODES - Continued 29
THE PAGE DISPLAY SYSTEM 29
ENTERING THE ACCESS CODES 30
USING THE TOUCH KEYS 30
CHANGING DIGITAL VALUES 31
PROGRAMMABLE SETTINGS 31
PROGRAMMABLE SETTlNGS – 32
CONFIGURING THE DETECTOR 33
CHANGE MODE 33
REJECT TIMERS – GENERAL 35
#### sec 36
PROGRAMING THE DETECTOR 46
PRODUCT EFFECT APPLICATIONS 47
SELECTING TIMER A B or C 49
SELECTING INVERSE DETECTION 49
CONFIGURING THE PVR 50
Alarm If Overdue 52
PASSED FAILED 52
PRINT-OUTS / DATA COLLECTION 53
APPENDIX A 54
For The tm3[G] Timer 54
Disc Construction 55
Of The Speed Sensor 55
HARDWARE FAILURE NO’S 57
VARIABLE ERROR NO’S 57
CIRCUIT FAULT NO’S 57
WARNING NO’S 58
WARNING DATE/TIME NOT SET UP 58
Connecting Your Printer 59
APPENDIX D 61
APPENDIX E 64
VIEWING Mode 65
Japanese Language 65
Due/Overdue Alarm Output 65
RUNNING MODE 67
OPERATOR MODE 68
SUPERVISOR MODE 69
ENGINEERS MODE 70
QA-OPERATOR MODE 72
QA-INSPECTOR MODE 73
AUTO SETUP SUB -ROUTINE 74
Tm2[G] TIMER SUB-ROUTINE 76
ATEX DIRECTIVE 80
ATEX system label 81
ATEX Static warning label 81
ATEX Enclosure warning label 81

Comentários a estes Manuais

Sem comentários

Safeline STANDARD SERIES Manual de Instruções Página 60

Comentários a estes Manuais