Safeline STANDARD SERIES Manual de Instruções descarregar pdf (Página 58)

Page 42

WARNING NO’S

During power-up the firmware checks the module

memory and the detector head memory for validity, any

errors are displayed as Warning Numbers.

If Warning 1 occurs it will be followed by the question:

Maintain Module YES>

settings ?? NO>

Select the ’YES’ soft key option - be patient it will take

several seconds to transfer the module settings to the

head.

Action

Ensure that the metal detector is not powered down for

30 seconds, following a change to any of the settings.

If the problem still persists contact the supplier.

Note: If it is the first time the metal detector has been

switched on with a new interconnection board then

there is nothing to worry about.

Warning 2, 3 and 4 are displayed continually and

prevent the system from running. Pressing any key will

put the metal detector into its normal running mode.

The metal detector may still be used if the message

was a Warning 4.

Action

Check all your programmed settings and the operation

of the system and contact the supplier.

OTHER FAULT MESSAGES

BALANCE FAULT CONTACT SUPPLIER

This message on the LCD prevents the metal detector

from operating and forces a reject condition.

If a Reject Confirmation Unit (RCU) is fitted and

operating the ‘system fault relay’ contacts will be

activated.

Action

Contact the supplier.

WARNING - No communications hardware.

This message appears on the LCD during power-up

‘SELF TEST’ if communications is configured in and

the module does not have the correct hardware.

The display remains for approximately 10 seconds and

then self clears.

Action

If RS232 communications is required contact the

supplier.

BAD ROM CHECKSUM FOUND: MACHINE FAULT

XXXX.

This message appears on the LCD during power-up

‘SELF TEST’ if a fault is found with the firmware.

This condition prevents the metal detector from

operating and forces a reject condition.

Action

Contact the supplier.

WARNING DATE/TIME NOT SET UP

The message will normally follow a WARNING 4

condition and is displayed continually preventing the

system from running. Pressing any key will put the

metal detector into its normal running mode.

Action

Set the date and time and check all your programmed

settings and the operation of the system and contact

the supplier.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 80 81

Comentários a estes Manuais

Sem comentários

Safeline STANDARD SERIES Manual de Instruções Página 58

Comentários a estes Manuais